Cino PL680BT HC - Manual (Page 18)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Getting Started
10
Use FuzzyScan in SPP Mode
Establish SPP Master Connection
Ensure the battery is fully charged. Please go to the folder “Hardware” located in Bluetooth Advanced Setting of the
remote host device to check its device MAC address. Then prepare a 12-character Code 128 barcode of the remote host
device MAC address, or follow the step 4 to input MAC address by scanning 12 option codes.
Ensure a virtual COM port is available in your remote host for connecting the scanner. If not, please go to the folder
“Local Services” located in Bluetooth Advanced Setting. Click the “Add Serial Services” to add one more Bluetooth
COM port.
Power on or wake up the scanner by pressing the Trigger key within radio coverage if the scanner is power-off or in sleep
status, and ensure the status indicator of scanner blinks red and green blinks alternatively (in “Uninstall” state). If the
scanner is not in uninstall state, please scan the “Uninstall” command first, then scan the “SPP Master Mode” command.
The status indicator of scanner will turn steady red immediately.
Uninstall SPP Master Mode
Scan a 12-character MAC address barcode, or scan 12 option codes and “FIN” command to confirm your inputs. The
scanner will emit continuous short clicks and the link indicator of the scanner will blink blue quickly during the radio
connecting process. If the PIN Code or Passkey is requested, please enter “00000000” (default setting).
The scanner will emit 4 beeps in ascending tone to indicate the radio is connected. At the same time, the link indicator of
scanner will blink blue once per 2.5 seconds to indicate the scanner is in radio-connected state.
Please note that if the scanner failed to connect to the host device within 30 seconds, the link indicator will blink blue 3
times per 2 seconds. But the scanner is still continuing to discover the host device for another 30 seconds before go to
sleep. In the interim, you still can scan “Uninstall” command to revert the scanner to uninstall state. If the scanner goes to
sleep already, you just need to press the trigger to wake up the scanner to continue the installation.
The above procedures are based on popular Windows environment. But the installation procedure may vary
depending on different remote host devices, operating systems and the Bluetooth drivers. Please consult your
professional IT consultant to obtain necessary support if any problem has been encountered during the installation
processes. For more detailed information, please visit CINO website.