American Energy Systems NPS-1005-N-7 Control Panel - Manual (Page 8)

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-7 Control Panel Kit LR New
Stlye.doc
INTRODUCTION
This section will explain the inputs/outputs, operation, and maintenance of new control board. Included are
helpful hints and suggestions that will make the operation and maintenance of the board an easier and more
enjoyable experience. We offer our continual support and guidance to help you achieve the maximum benefit
from our units.
Important Information:
The information provided in this document applies to Program Revision 18 of NEW CONTROL board and may
not be applicable to other revisions.
THE CONTROL BOARD DESIGN
The Figure 1 shows the design/layout of the control board for
NEW CONTROL.
NEW CONTROL has following INPUT(s) to control the
system functions.
1.
ON/OFF Switch
2. AUTO/TSTAT/MANUAL Switch
3. AUGER TRIM/FEED Switch
4. HEAT CONTROL UP
5. HEAT CONTROL DOWN
6. DRAFT/FAN TRIM
7. HIGH FAN TRIM
NEW CONTROL has following OUTPUT(s) to display the system functions.
1.
POWER ON/OFF LED
2. PRIME ON/OFF LED
3. HEAT LEVEL INDICATION/ALARM LED
FIGURE 1: THE DESIGN