American Energy Systems MF3573 Auger Motor User Manual
Page 2
• Slide on the auger motor by aligning the flat shaft on the auger to the Allen screw on
shaft collar and then tighten the set screw on the collar.
• Reconnect auger motor electrical leads and make sure wires are secured properly in the
right panel.
• Close side panel.
• Restart unit.
F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3573 Auger Motor.doc
See also other documents in the category American Energy Systems Kiln:
- MagnuM Countryside (44 pages)
- MagnuM Countryside (39 pages)
- MF3513S Fuel Stirrer (2 pages)
- MF3514 Fuel Stirrer Drive Shaft (1 page)
- MF3522 Door (2 pages)
- MF3540 Fuel Stirrer Motor (2 pages)
- MF3542 Exhaust Blower (3 pages)
- MF3553 Auger Inspection (1 page)
- MF3650 Exhaust Blower (3 pages)
- P7554 Brick Board (1 page)
- BC2077 Door (3 pages)
- BC2500 Auto Ignition System (2 pages)
- BC3525 Grill (1 page)
- BC3555 Grill (1 page)
- BC7000 Auger Housing (9 pages)
- MF3626 Door Handle (3 pages)
- MF3642 DC Fan Blade - Exhaust Blower (2 pages)
- RP2062 DC Wire Harness (2 pages)
- RP2063 AC Wire Harness (2 pages)
- RT080 (2 pages)
- MagnuM Baby Countryside (43 pages)
- MagnuM Baby Countryside (42 pages)
- MagnuM Winchester (52 pages)
- MagnuM Winchester (49 pages)
- MagnuM Winchester (51 pages)
- CF25 Room Fan Blower (2 pages)
- P6115 Wire Harness (2 pages)
- MagnuM 6500 (44 pages)
- MagnuM 6500 (45 pages)
- MagnuM 7500 (43 pages)
- MagnuM T40 (50 pages)
- MagnuM T40 (19 pages)
- MagnuM T40 (32 pages)
- MagnuM T40 (31 pages)
- MagnuM ZC (5 pages)
- CF-2200 Door (1 page)
- NPS-1005-N-7 Control Panel (11 pages)
- PP-1030-LR Wire Harness (3 pages)
- PP-1502 Auger Weldment (2 pages)
- Country Flame Little Rascal (35 pages)
- Country Flame Little Rascal (37 pages)
- Harvester (44 pages)
- Harvester (57 pages)
- Crossfire Flex (58 pages)