Alwarerc Senrigan GP-35 Brushless Gimbal For DJI Phantom 1/2 - Manual (Page 18)

8. Power On Steps
Before Power On the Gimbal:
1. Please check the polarity of the JST connectors.
2. Make sure the IMU is installed on top of the Upper Camera Cover correctly.
Refer to IMU Mounting section.
3. Use only 3S 11.1V Lipo Battery for your Phantom.
4. The Brushless Gimbal Controller has been tuned perfectly to plug-n-play with GoPro 3 camera on
Phantom.There is no additional tuning needed.
Follow the following sequencies to power on your Senrigan-GP-35 Brushless Gimbal correctly.
Step 1.
Turn on your Phantom's Trnsmitter.
Step 2.
Power on the Phantom with 3S 11.1V Lipo Battery. Keep the whole machine steady when power on and wait
for around 5 seconds for the Phantom and the Gimbal to performance the initialization.
Step 3.
If the initialization step is successful, GP-35 Gimabl will level the Gopro 3 Camera slowly for both Tilt and
Roll axis. Otherwise power cycle the system and try again.
Step 4.
Ready to go.
Page 18 of 19