Alwarerc Senrigan GP-35 Brushless Gimbal For DJI Phantom 1/2 - Manual (Page 15)

Step 5.
Insert 1-wire End connector of the into the casing of
the Phantom. Step 6.
Insert the 1-wire End connector into F2 port of NAZA
controller in the Phantom.
(Pay attention to the
position (use the Lowest Pin) of the connector.)
Step 7.
Please be noted that the 3-wire End connector is
useless when using the original Transmitter of
Phantom. You can just fix this connector on the
landing gear of Phantom for better appearance. Step 8.
Connect the 4-wire End connector to the Gimbal
Controller Board.
(Pay attention to the direction.)
Cover the Top Casing back to Phantom and now is
ready to setup the Gimbal Tilt control with the
Assistance Software of Phantom (NAZA).
Page 15 of 19