Alwarerc Senrigan GP-35 Brushless Gimbal For DJI Phantom 1/2 - Manual (Page 14)

6. Assembly Steps – Power Connection and
Manually Tilting
Step 1.
Take off the Top cover of your Phantom. Please refer
to the manual of DJI Phantom.
Make sure the Power cable in the Phantom is passing
through the casing. Step 2.
Solder the Male JST Connector to the Power cable of
the Phantom.
(Important: Solder Red to red wire, and
black to brown wire!)
Step 3.
Connect the JST connectors to the Gimbal Controller
Board. Step 4.
Name for each end of the Tilt and Roll Controlling
Connector.
Page 14 of 19