4 ipmi command, 1 deactivate and activate, I2c to i/o device access – ADLINK aTCA-N700 User Manual

Page 21

Text mode
Original mode

aTCA-RN720 User's Guide

4.4 IPMI Command

When the front blade is up and running the aTCA-RN720 is ready to receive commands from a
shelf manager in the chassis. This section summarizes some command execution examples and
their responses based on the factory environment. Actual commands may differ per different shelf
manager at customer environment.

4.4.1 Deactivate and Activate

One can deactivate and activate the aTCA-RN720 at any state. Attached below are the example
runs.

Step 1

. Make sure FRU Statue is at M4 by running clia command at the shelf manager.

Step 2

. Deactivate the FRU and check the status.