Acrosser AR-B1047 User Manual
Page 17
AR-B1047 User’s Guide
3-2
To execute PGM1047.EXE, the main menu will be displayed on your screen. There are 8 options on the main
menu.
Quit to DOS
Quits and exits to the DOS.
OS Shell
Exits from PGM1047 temporarily to the DOS prompt. Type EXIT to return to PGM1047 main menu.
Load ROM File
If this option is used, the PGM1047 will prompt you for the ROM pattern file name. This option is useful if you
have not previously entered a ROM pattern file name or if you wish to use a different ROM pattern file. The
PGM1047 will check and display the ROM file name, ROM file size, (FLASH) memory capacity and the number
of ROM pattern files that will be loaded and copied onto the (FLASH) memory chips.
Verify Memory
If ROM pattern files were loaded without error, this option instructs PGM1047 to verify the contents of (FLASH)
memory chips with the current ROM pattern files.
Program Memory
If there are no mistakes in your ROM pattern file, then this menu option will erase (FLASH) memory, write the
current ROM pattern files onto (FLASH) memory and verify data that was just written to (FLASH) memory, using
the ROM pattern files.
Memory Type/Mfr.
Before you program the (FLASH) memory chips, make sure that the FLASH’s type and manufactory match the
one shown on the main menu. Otherwise, you can use this option to select the proper type and manufacture
and instruct the program to use a right programming algorithm.
Select PGM Chips
Normally the PGM1047 will program all ROM pattern files onto the FLASH memories with the ROM pattern files
just loaded. But you can use this option to select which memory chips that you want to program and which
memory chips need to be skipped. The PGM1047 will only program the selected chips when writing data to the
FLASH memory. This is very useful when some of the memory chip were verified and programmed previously.
Select FLASH PLSCNTs
If the 12V FLASHs have been programmed several times, please select the
instead of
program data onto the 12V FLASHs correctly.
The default setting is
(B) WP1047.EXE
WP1047.EXE
This program demonstrates how to enable and disable software writes protect function. It also
shows the current protect mode of write or read only memory.