Acrosser AR-B1047 - Manual (Page 11)

AR-B1047 User’s Guide
2-4
2.3 DIP SWITCH SETTING (SW1)
There is 1-DIP Switch located on the AR-B1047. If you want to use the 12V FLASH, please use the external 12V
voltage, the AR-B1047 does not support the 12V voltage. It performs the following functions:
ON
1 2 3 4 5 6
OFF
7 8
SW1
Figure 2-8 SW1: Switch Select
SW1-1 Sets the base I/O port address
SW1-2 & SW1- 7 Sets the starting memory address
SW1-3 & SW1-4 Sets the drive number of solid state disk
SW1-5 & SW1-6 Sets the used ROM memory chips
SW1-8 Set the DiskOnChip
2.3.1 I/O Port Address Select (SW1-1)
SW1-1 is provided to select one of the two base port addresses for the solid state disk. The AR-B1047 occupies 2
I/O port addresses. Following state selections of base port address.
Switch 1 (SW1-1) Base Port Solid State Disk
OFF 224h 224h-227h
ON 2A4h 2A4h-2A7h
Table 2-1 I/O Port Address Select
2.3.2 SSD & DiskOnChip Firmware Address Select (SW1-2, SW1-7 & SW1-8)
The AR-B1047’s SSD firmware occupies 8KB of memory. SW1-2 and SW1-7 are used to select the memory base
address. You must select an appropriate address so that the AR-B1047 will not conflict with memory installed on
other add-on memory cards. Additionally, be sure not to use shadow RAM area or EMM driver’s page frame in this
area.
Switch 2
(SW1-2)
Switch 7
(SW1-7)
Switch 8
(SW1-8)
BIOS
Memory
Address
Bank
Memory
Address
D.O.C.
Memory
Address
OFF OFF OFF CC00h CE00h D000h
ON OFF OFF D000h D200h D400h
OFF OFF ON CC00h CE00h --
ON OFF ON D000h D200h --
OFF ON OFF -- CE00h CC00h
ON ON OFF -- D200h D000h
OFF ON ON -- -- --
ON ON ON -- -- --
Table 2-2 SSD Firmware Address Select
If you are not going to use the solid-state disk (SSD), you can adjust the SW1-7 to disable the SSD BIOS. The
AR-B1047 will not occupy any memory address if the SSD BIOS disabled.
If you are going to install the EMM386.EXE driver, please use the [X] option to prevent EMM386.EXE from using
the particular range of segment address as an EMS page is used by AR-B1047. For example, write a statement in
the CONFIG.SYS file as follow: (If the memory configuration of AR-B1047 is CC00:0)
DEVICE=C:\DOS\EMM386.EXE X=CC00-CFFF