Acrosser AR-B1047 - Manual (Page 16)

AR-B1047 User’s Guide
3-1
3. INSTALLATION
The chapter describes the various type SSDs’ installation steps as follows. The jumper and switch adjust as SSD’s
different type to set.
! Overview
! ROM Disk Installation
! Using the Write Protect Function
! Memory Device Supported
! How to Use the D.O.C.
CAUTION: When the power is turned off, please note the following precautions.
1. If your data has been stored in the SRAM disk, do not change the jumper position or data will be
lost.
2. Make sure jumpers are set properly. If you mistakenly set the jumpers for SRAM and you have
EPROM or FLASH installed, the EPROM or FLASH will drain the battery’s power.
3. If you want to use the 12V FLASH, please use the external 12V voltage, the AR-B1047 does not
support the 12V voltage.
3.1 OVERVIEW
This chapter provides information for you to set up a working system based on the AR-B1047 card. Please read
the details of the card’s hardware descriptions before installation carefully, especially jumper settings and cable
connections.
Follow steps listed below for proper installation:
Step 1 : Make sure the base I/O address does not conflict with other I/O cards.
Step 2 : Make sure the memory address does not conflict with other memory cards.
Step 3 : Make sure the jumper settings for the memory are all installed properly.
Step 4 : Don’t use the shadow RAM on the firmware address.
Step 5 : If you have installed an EMS driver, don’t use the same range of memory address as the AR-B1047.
Step 6 : If you are using the MS-DOS 6.2 to format SRAM or small page 5V FLASH disk, you might get some bad
sectors in your FLASH/RAM disk. This will reduce the capacity of your FLASH/RAM disk. To solve this
problem, please type:
C:\>FORMAT [FLASH/SRAM disk letter] /S/U/C
or
C:\>FORMAT [FLASH/SRAM disk letter] /U/C
3.2 ROM DISK INSTALLATION
To support the AR-B1047 solid state disk’s operations, the following files has been provided some functions as
follows:
(A) PGM1047.EXE
PGM1047.EXE PGM1047.EXE is used to program the 12V FLASH EPROM after the ROM pattern files are
generated by RFG.EXE. The PGM1047.EXE can also program the correctness of the ROM
pattern files onto 5V FLASH EPROM (start from MEM1) or SRAM for testing the ROM pattern files.