Delfield UC4460N-8 - Manual (Page 4)

Exterior top is one-piece 22-gauge stainless steel with
integral 2.12” (5.4cm) square nosing at the front. Top of
drawer unit has openings to accept 8 or 12 1/6-size 4”
(10cm) deep plastic pans. Top of door unit has openings
to accept 8 or 12 1/6-size 4” or 6” (10cm or 15cm) deep
plastic pans. Adapter bars and 1/6 pans are supplied by
Delfield. Temperature in top opening to maintain 33°F
(1°C) to 41°F (5°C), with pans recessed 2.5” (6.4cm) at 86°F
ambient room temperature, meeting NSF 7 requirements.
One 60” x 10” x .5” (152cm x 25.4cm x 1.3cm) polyethylene
cutting board treated with antimicrobial agent is mounted
on the top at the front edge.
Dual level pan brackets allow the pans to be lowered
an additional inch in the unit without tools to provide
additional pan temperature holding performance.
Exterior back and bottom are two-piece 24-gauge
galvanized steel. Exterior ends are stainless steel.
Interior sides are thermoformed ABS plastic with shelf
supports. Base is fully insulated with high-density
foamed in place environmentally friendly, Kyoto Protocol
Compliant, Non ODP (Ozone Depletion Potential), Non
GWP (Global Warming Potential) polyurethane.
Refrigeration system uses hFC-404A refrigerant.
Compressor is 1/2 h.P., with condenser coil and condensate
evaporator mounted on rear of the cabinet. Evaporator
coil is located on the interior rear wall of the cabinet.
Refrigerant flow is controlled by a capillary tube. Cabinet
maintains an interior cabinet temperature of 36°F to 40°F
(2°C to 4°C).
ACT control: ACT electronic, solid state control, mounted
on the exterior rear of the cabinet, allows unit to maintain
precise temperatures in heavy duty conditions.
Specifications
UC4460N Salad Top
Reduced Height Front-Breathing Self-Contained Salad Top Refrigerated Bases
Electrical connections are 115 volt, 60 hertz, single
phase. Unit has a 6’ (1.8m) long electrical cord and NEMA
5-15P plug.
Casters: Equipment is mounted on 3” (7.6cm) diameter
plate casters. Equipment clearance above the floor is 0.66”
(1.7cm).
Doors have a 24-gauge stainless steel exterior, with
thermoformed ABS plastic interior liner. Cabinet has one
adjustable epoxy-coated wire shelf per door opening.
Drawer fronts have a 24-gauge stainless steel exterior,
with thermoformed ABS plastic interior liner. Drawer
frames are 12-gauge stainless steel. Drawer slides are
11-gauge stainless steel with Delrin bearings. Each
section has two drawers. Each top drawer holds one full
size 12” x 20” (30.5cm x 50.8cm) pan, three 1/6 size and
three 1/9 size 4”-6” (10.2cm -15.2cm) deep pans. Each
bottom drawer holds one 12” x 20” (30.5cm x 50.8cm) pan,
three 1/6 size and three 1/9 size 4” (10.2cm) deep pans.
Pans supplied by others.
980 S. Isabella Rd.
Mt. Pleasant, Michigan 48858 Phone: 800-733-8948 or 989-773-7981
Fax: 800-669-0619
www.delfield.com Printed in the U.S.A.
DSUC4460N-S
03/13