Akai Multi Video Processor RMD-V3104U - Manual (Page 45)

MVP MANUAL
The relative address and data are as follows.
However, relative addresses 20 to 3F are the system reservation range.
Relative
ADDR
Data Contents
Relative
ADDR
Data Contents
00 Model data No. 10 Reservation
01 Horizontal frequency 11 Vertical frequency
02 NNN.NNN kHz 12 NNN.NNN kHz
03 (BCD 6 digits) Note 1 13 (BCD 6 digits)
04 Total horizontal dots 14 Total vertical line number
05 (BCD 4 digits) 15 (BCD 4 digits)
06 Horizontal effective start position 16 Vertical effective start position
07 (BCD 4 digits) 17 (BCD 4 digits)
08 Horizontal effective dot number 18 Vertical effective line number
09 (BCD 4 digits) 19 (BCD 4 digits)
0A Clamp head 1A Line conversion rate Note 4
0B Clamp period 1B
0C Gain upper limit 1C Reservation
0D Clamp upper limit 1D
0E Sync method Note 2 1E PLL gain
0F Sync polarity Note 3 1F Reservation
Note 1
Note 2
Note 3
Note 4
For example, taking the PC98 table on the previous page as an example, as the relative addresses 01,
02, and 03 contain data 02, 48, and 30, the PC98 horizontal frequency setting value is 24.83 kHz.
FF when the method is not limited.
FF when the polarity is not limited.
If the relative address data is:
65 : Indicates 6-5 conversion
A7 : Indicates 10-7 conversion.
(22) Horizontal frequency input [HFQ command]
Input : HFQdid2d3.d4d5d6
Explanation :• Directly changes the horizontal frequency of the model data table used for the VS board cur­
rently.
• Input the frequency using 6-digit decimal numbers. When data input is omitted, the horizontal
frequency on the current model data table is displayed.
• Refer to "Using Methods of HFQ, VFQ, VLN” described later on the using methods.
(Example)
HFQ035.12^ <----------------------------------------------------------- Input 35.123 kHz
(Take note to input 0 at first.)
Although numbers outside the horizontal frequency specification range (24.0 kHz to 35.0 kHz)
range of this board can be input, they cannot be used as preset data.
171