5) to set the output to the ntsc mode [nt command – Akai Multi Video Processor RMD-V3104U User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MVP MANUAL
(5) To set the output to the NTSC mode [NT command]
(6) To set the output to standard RGB mode [NTR command]
(7) To set the output to the double-speed RGB mode [NTD command]
Input :
NT s, NTR 0, NTD 0
Explanation : • NT : Sets the NTSC input mode.
H : 15.734 kHz
V : 59.94 Hz
Composite video, Y/C output
• NTR : Sets the standard speed RGB mode.
H : 15.734 kHz
V : 59.94 Hz
• NTD : Sets the double-speed RGB mode.
H : 31.469 kHz
V : 59.94 Hz
• This command is executed in the remote mode.
It is ignored in the manual mode. (Refer to the RMT command.)
(NOTE)
With the RMD-V2550U, only standard speed input is possible.
(8) Optional variable scan board adjustment mode settings [:A command]
Input :
: A 0
Explanation: • Used when adjusting the optional variable scan board (RMD-V3020).
• To exit the adjustment mode, omit the parameters and input 0D.
• For details on adjustments, refer to ”VS Board Command Reference” on the following pages.
156