Adcom GTP-740 User Manual

Page 41

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3) Tune to the next desired frequency and follow the same instructions but use “Preset 2” to

commit this new broadcast frequency to memory.

4) Continue for all presets up to and including the seventh.

5) Setting presets 8 through 14 require the use of the shift button.

•

Select the desired frequency for preset # 8. Press shift and then hold preset button
1 for three seconds. When you see “Preset 8” appear in the information display and
the LED’s in the front panel preset 1 and shift buttons light, that frequency is

memorized.

•

Select the frequency for preset # 9. Follow the instructions above but substitute
preset button 2 in place of preset button 1. (Remember that the shift button adds a

“7” to the nominal preset button value. Thus, shift + 2 actually means “Preset 9” and
so on.)

•

Continue as above until all 14 presets are used or until you run out of “favorite"
stations, whichever comes first.

6) Select the other broadcast band (AM or FM) and begin programming again. Follow the

instructions above. When you're finished, you’ll be able to listen to any of these favorite
frequencies by pushing just one or two buttons.

Listening to “preset" stations

1) Select tuner and either FM or AM.

2) Press the appropriate preset button (or shift + the preset button for choices higher than

“preset 7”).

3) Enjoy.

4.2 Room 2 Operation

Introduction

The GTP-740’s “Room 2” circuitry give you the ability to simultaneously enjoy two different
audio/video sources in two different areas of your home. For instance, you can watch a DVD

movie in the main family room while someone else enjoys a satellite broadcast or CD in the
bedroom.

Full “Room 2" capability requires an infrared sensor and a reliable data link between that sensor

and the GTP-740. Consult you ADCOM dealer for details and assistance if necessary.

Selecting a “Room 2” source

Note: Although you can select a “Room 2” source from the GTP-740’s front panel, you probably

won’t want to do this very often. The preferred, and far more practical, method is via the remote

control link between whatever area of your home you've designed “Room 2” and the GTP-740

1) Press the room 2 button (# 17 on the front panel, #54 on the remote) once. The LED in the

center of the room 2 button will light to tell you that “room 2” capability is on.