Adcom GTP-740 - Manual (Page 27)

+ 10 Not programmable + 10 Programmable Programmable
SHIFT Not programmable Call Presets 8 - 1 4 Programmable
FM/AM Not programmable Repeat FM or AM select Programmable
STEREO Stereo mode select Program/Mem. Stereo/Mono Programmable
SRND Surround mode select Random play Programmable Programmable
ENTER Not programmable Time display Seek/Manual Programmable
D. RANGE Dynamic range adjust Disc 1 Programmable Programmable
REAR + Rear level up Disc 2 Programmable Programmable
CENTER + Center level up Disc 3 Programmable Programmable
SUB + Subwoofer level up Disc 4 Programmable Programmable
BAL. CHK Balance check Disc 5/
Memory clear Programmable Programmable
DIALOG Dialog enhance on/off A-B repeat Programmable Programmable
REAR- Rear level down Clear repeat Programmable Programmable
CENTER - Center level down Programmable Programmable Programmable
S U B - Subwoofer level down Programmable Programmable. Programmable
DIM Dim display Programmable Dim Display Programmable
Ml For Macro use For Macro use For Macro use For Macro use
M2 For Macro use For Macro use For Macro use For Macro use
M3 For Macro use For Macro use For Macro use For Macro use
M4 For Macro use For Macro use For Macro use For Macro use
ROOM 2 Room 2 source select Programmable Programmable Programmable
MUTE Mute volume Mute volume Mute volume ProgrammaUe
PROGRAMMING YOUR ADCOM REMOTE CONTROLLER
Introduction
The ADCOM universal remote controller operates eight different audio/video components. As you’ve
already seen, it’s preprogrammed to control ACCOM’s GTP-740 Preamp/Tuner and the GCD-700 CD
player. In ¿ddition, K has five “component 'memory banks” available so you can program the remote to
learn commands for your DVD player, satellite box, laserdisc player, VCR, etc. This lets you use one
remote controller for your entire system.
Using Preprogrammed Commands
Using the remote controller’s preprogrammed commands is simple. For most GTP-740 functions (volume
up/down, changing surround modes, etc.), follow these easy steps.
1.
2 .
Press the main source selector button. This tells the remote that you want to use GTP-740
preprogrammed commands. The main button will flash red to tell you it understands.
Press the appropriate function button (volume up, volume down, etc..) If you’ve selected a button
that actually triggers a GTP-740 command, the main button will again flash red to confirm your choice.
If the main button does not flash, you’ve selected a function button that isn’t preprogrammed.
(Review the table above to see which buttons are preprogrammed.)
26