Adcom GTP-740 - Manual (Page 13)

19 Digital audio/standard (composite) video inputs
Remember that you must choose either standard (composite) or S-Video
connections before hooking up source components. This section of the manual
assumes you have chosen composite connections. S-Video connections will be
handled in a subsequent section. _________
DVD in: Connect the DVD player’s composite video output to the yellow-center RCA jack
immediately under the “DVD in” label.
Connect the DVD player's RCA-style digital output jack to the GTP-740’s black-center
RCA jack located under the “DVD in" label.
Note: If your DVD player has only a TOSlink (optical) digital output, you may need to
connect it to “dig. aux in." If this is the case, remember to connect the player’s video
output (composite or S-Video) to the appropriate “dig. aux in" jack.
Dig Aux In; This Input is recommended for an audio/video source (DSS receiver, etc.) with a
TOSlink (optical) digital output.
Remember that the composite video connection will go to the yellow-center RCA jack
immediately under the "dig. aux in" label.
Connect the source’s TOSlink (optical) digital output to the GTP-740’s TOSlink socket
located under the "dig. aux in" label.
Dig RF in: We recommend this input for laserdisc players with a digital RF output. It is the only
input on the GTP-740 equipped with the RF demodulator needed to process a laserdisc’s
Dolby Digital encoded soundtrack.
Connections follow the same pattern detailed in “DVD in" and “Dig. aux in” above.
Connect the laserdisc player’s composite video output to the yellow-center RCA jack
immediately under the “dig. RF” label, then connect the player’s coaxial digital output to
the black-center RCA jack under the “dig. RF in” label.
12