beautypg.com

Adcom GTP-740 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

LD in; Connect the LD player’s S-Video output to the mini-DIN connector under the S-Video

“LD in” label.

VCR in: Connect the VCR's S-Video output to the mini-DIN connector under the S-Video

“VCR in” label.

VCR out; Connect the VCR’s S-Video input to the mini-DIN connector under the S-Video

“VCR out” label.

Video aux in: Connect the source’s S-Video output to the mini-DIN connector under the S-Video

“video aux in” label.

Room 2 output; Connect the video display device to the S-Video mini-DIN output under the

“room 2 out” label.

S-Video monitor outputs: Connect the main monitor or display device to the mini-DIN jack

under the “S-Video monitor 1" label. You may use the “S-Video monitor 2” Jack for
another monitor if desired. Properiy connected, either monitor will then display an
image from a video source or on-screen menu information when appropriate.

Ball System input and output: Connect the BOS-500's S-Video output to the mini-DIN jack

immediately under the “ball sys in" label. Then connect the BOS-500’s S-Video input to
the mini-DIN jack under the “ball sys ouf label.

24

Ball System On/Off switch

This switch controls a “video loop" that enables the GTP-740 to function seamlessly with
ADCOM’s Ball System controller.

For conventional high performance home theater systems, make sure the “ball sys on/off switch
is in the off position. When using the Ball System controller, place this switch in the on position.

25

Remote control connections

Infrared

repeater

IR

mini lack

© © ©

remote sensor

extension

Infrared repeater: These mini-jack outputs transfer command codes received from either the IR

mini-jack or remote sensor extension inputs to an IR repeater located close to other
system components. IR signals received at the GTP-740’s front panel IR receptor are
NOT available at the infrared repeater outputs.

IR mini-jack: This input receives IR command codes from remote sensors.

Remote sensor extension inputs: These inputs receive signals from ADCOM’s XR500II and

SPM500II remote control sensors.

17