Adcom GTP-740 - Manual (Page 19)

26 Preamplifier outputs
These are the GTP-740’a main outputs,
channel as follows; Connect each to the proper amplifier or amplifier
1) Connect the white-center RCA output marked “front L(eft)" to the amplifier channel
designated for the left front loudspeaker.
2) Connect the red-center RCA output marked “front R(ight)" to the amplifier input
designated for the right front loudspeaker.
3) Connect the white-center RCA output marked “rear L(eft)” to the amplifier input
designated for the left rear loudspeiaker.
4) Connect the red-center RCA output marked “rear R(ight)” to the amplifier input
designated for the right rear loudspeaker.
5) Connect the black-center RCA output marked “center" to the amplifier input
designated for the center channel loudspeaker.
6) Connect the black-center RCA output marked “subwoofer" to the amplifier input (in
most cases, the line-level input of a powered subwoofer) designated for the
subwoofer.
27
Note: There are two subwoofer outputs (1 & 2.) They are in parallel (i.e., each produces
an identical signal) and may be used interchangeably. We've included these outputs to
make it easier to add a sepond subwoofer, if desired.
AC fuse holder
This holder provides easy access to the AC line fuse if that fuse needs replacement. To gain
access to the fuse, insert a Phillips head screwdriver and turn counterclockwise. After replacing
the fuse, reseat the holder by turning clockwise until the holder is firmly seated.
When replacing the fuse, ALWAYS use one of equal value (for domestic models use an FSOOmA,
250V fuse available at any electronic parts store.) NEVER use a fuse of higher value. If the fuse
fails again, consult your ACCOM dealer or call the ADCOM Service Department directly.
28 AC power cord (115VAC models)
Make sure to seat this cord firmly in an unswitched wall socket to provide uninterrupted power to
the GTP-740. When removing the cord from an AC socket, NEVER pull on the cord itself.
Instead, grasp the plug firmly and remove it from the socket. You may need to “rock” the plug
lightly for easier removal.
28a AC power cord receptacle (export models)
This I EC-standard socket accepts a wide variety of AC power cords.
18