Aiwa CSD-ED87 - Manual (Page 4)

REPEAT/
FM MODE/
ose
□
1
TUNER OPERATION
Press *RADIO/BAND repeatedly to select the
desired band.
I—> FM —> AM —I
The power is turned on and the previously tuned
station is received.
The RADIO indicator lights up.
* or BAND on the remote control (applicable when the
AC cord is connected)
2
Press {+, - TUNING) to select a
station. ^^
During FM stereo reception, I STEREO] is displayed.
After listening, press POWER 6 STANDBY to turn the
power off.
For better reception
FM
□□
E5Q
play / pause / preset
£ 3
STOP/MEMORY taiddd
- TUNING +
POWER Ò STANDBY BAND
TAPE RADIO CD J
NOTE
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent lights, move the unit.
PRESETTING STATIONS
You can preset up to 15 stations in each band.
1
2
Select a station.
Press *■ STOP/MEMORY once so that “M” is
displayed to store the station.
A station is assigned a preset number, beginning from 1
in consecutive order for each band.
“M” may not be displayed if the button is kept pressed for
more than 0.5 second.
Preset number
(am
Extend the FM antenna and The AM antenna is inside
orient it for the best reception. the unit. Position the unit
for the best reception.
For quick tuning
Keep +, — TUNING pressed until the tuner starts
searching for a station. When a station is tuned to, the
search stops.
If the broadcast signal is weak, it does not stop. To stop
the search manually, press + or —.
*REPEAT/FM MODE/OSC
- If an FM stereo broadcast contains noise, press the
button so that IMONOI is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
- If a high-pitched sound is heard during AM recording,
press the button repeatedly until the noise is reduced. Its
position can be checked by being on or off the display.
* or MODE on the remote control
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kFIz/step.
If you use this unit in an area where the frequency
allocation system is 9 kHz/step, change the interval as
follows.
1 Press RADIO/BAND to display FM.
2 Press ■ while pressing RADIO/BAND to display the
AM frequency.
When the AM tuning interval is changed, the preset
stations are cleared.
4 ENGLISH
MHz
Frequency
* or ■ on the remote control
3
Repeat steps 1 and 2.
The next station will not be stored if a total of 15 preset
stations have already been stored for a band.
To listen to preset stations
Select a band then press ►!! PLAY/PAUSE/PRESET
repeatedly.
► PLAY on the remote control is also available.
To select a preset number directly with the remote
control
Press the numbered buttons 0-9 and - h IO.
Example:
To select number 15, press +10 and 5.
To select number 10, press +10 and 0.
To clear a preset station
Display the preset number first. Then, press ■ while the
preset number is displayed.
The higher numbers in the band are decreased by one.