Aiwa Z-L31 - Manual (Page 20)

TURNTABLE
To check the timer setting
Press TIMER.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press
ENTER twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER so that © disappears.
To restore the timer standby mode, press TIMER again to display
®.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 and 6.
2,4
' Timer playback and timer recording will not begin unless the
power is turned off.
' Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
Preparation
• Connect the supplied stereo turntable to the main unit. (See
page 4)
• Set EQUALIZER AMP. selector on the turntable to ON position.
(Refer to the operating instructions of the turntable for details.)
1 Press PHONO on the main unit.
“PHONO” appears on the display.
2 Adjust the volume to minimum.
Turn VOLUME counterclockwise until “VOL 0” is displayed.
3 Play the turntable.
Refer to the operating instructions of the turntable for details.
4 Adjust the volume according to your preference.
20
ENGLISH