Aiwa CSD-MD50 - Manual (Page 27)

To check or change the specific items
Press the TIMER/CLOCK button repeatedly until TIMER PLAY?
or TIMER REC ? appears, then press the ENTER button within
5 seconds.
Each time the ENTER button is pressed, each item is displayed.
If you want to change the specific items, press the ◄◄ or ►►
button or turn the MULTI JOG dial.
To cancel timer standby mode temporality
Press the TIMER/CLOCK button repeatedly until TIMER OFF ?
appears, and press the ENTER button within 5 seconds.
To use the unit in timer standby mode
You can use the unit normally.
For timer play, make sure the source is correctly set before turning
the unit off.
SETTING THE SLEEP TIMER
■ If the unit is left for one minute at steps 4 to 7, the timer setting
mode is canceled.
' Timer play and timer recording will not begin unless the power
is turned off.
QC
LU
The unit can be turned off automatically at a specified time.
1 Press the TIMER/CLOCK button repeatedly until
SLEEP ? appears on the display.
2 Within 5 seconds, press the ENTER button.
3 Within 5 seconds, turn the MULTi JOG dial to
specify the time untii the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
Specified time
4 Press the ENTER button.
If you leave the unit without pressing the ENTER button, the
sleep timer will be activated after 5 seconds automatically.
While the sleep timer is activated
The display brightness becomes darker.
To check the time remaining until the power is turned
oflf
Press the TIMER/CLOCK button repeatedly until SLEEP ?
appears, and press the ENTER button. The remaining time is
displayed for 5 seconds.
To cancel the sleep timer
Select SLEEP OFF at step 3 above, then press the ENTER
button.
ENGLISH
27