Aiwa ADC-EXI06 - Manual (Page 3)

PRECAUTIONS
• Do NOT install the unit in a location where it
may be subjected to:
— Direct sunlight or other sources of excessive
heat
— Fluid, rain or moisture
— Excessive dirt or dust
— Excessive vibration
• This unit is designed to be operated on a 12-volt
DC negative-ground electrical system only.
• Choose the mounting location carefully so that
the unit will not interfere with normal driving
functions.
• Before making connections, disconnect the 0
terminal of the car battery to avoid short
circuiting.
Notes on CDs
• A defective or soiled disc stored in the disc
magazine can cause the sound to drop out
during play.
• Always handle a disc by holding its inner and
outer edges.
Do NOT touch the surface of the unlabeled side
of the disc.
Do NOT attach paper or tape etc. to a disc.
' Do NOT expose the discs to direct sunlight or
excessive heat.
■ Clean the discs before inserting them into the
disc magazine. Always clean a disc from the
center outward with a cleaning cloth.
' There may be burrs left on the inner and outer
edges of a brand-new disc. The burr may
cause the malfunction of the unit or sound drop­
out. To prevent these problems, if the burr is
left on the disc, be sure to remove them with a
bail-point pen, etc. as illustrated.
Bail-point pen
Burr
Bail-point pen
• N EVER use solvents such as benzine or alcohol
to clean a disc.
• You cannot play an 8-cm (3-inch) CD — even
with the specially designed adaptor.
• Do NOT use irregular shape CDs (example:
heart-shaped, octagonal ones).
It may result in malfunction.
Notes on the disc magazine
• Do NOT leave the disc magazine in a place
subject to excessive temperature or humidity.
• Do NOT insert more than one disc per siot.
• Do NOT drop the disc magazine.
m
z
o
r
(Ô
X
ENGLISH
2