ALESIS HR-16:B User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMAINING MEMORY
Holding RECORD and pressing LENGTH causes the following display:
REMAINING MEMORY
100 PERCENT
This shows the amount of memory that has not been used. Note that some
operations may not be possible even though it seems that there is still a small
amount of memory available. This is due to the fact that the HR-16 requires
enough memory to duplicate a pattern before it can be recorded on, or length
changed, or offset, etc. If a large pattern is attempted to be altered when there is
not enough memory to complete the operation, the display will indicate that there
is not enough memory available to complete the operation.
CLEARING MEMORY
To clear all of the HR-16's memory and reinitialize all of its variables, turn
power off, press and hold ERASE, DELETE, and RECORD, and turn on the power
while holding these buttons down for 3 seconds.
Alesis HR-16 Instructions