Tape – ALESIS HR-16:B User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
hit. These curves will also effect MIDI Input triggering of the drums. In addition,
MIDI input velocity sensitivity allows 32 steps of volume control per drum when
used with external controllers such as drum pads or sequencers. Note, however,
that recording MIDI input information on the HR-16 will only store 8 steps of
velocity inside the HR-16's internal record memory.
SONG LOOP
The SONG LOOP function turns on or off song looping. The display is as follows:
14 SONG LOOP
ENABLE: OFF_______
The
+!-
arrow buttons are used to turn this function on or off. The default is OFF.
When ON, a song that reaches its end will loop back to the beginning of that song.
TAPE
The TAPE button is used to access the tape interface features of the HR-16. This
allows the user to save and retrieve sequence data with an ordinary cassette
recorder. Pressing and holding the TAPE button results in the following display:
SAVE ALL PATTS &
SONGS TOTAPE
Pressing the RECORD button initiates the save to tape. Both buttons can now be
released, since this operation may take over two minutes, during which the
display will read:
SAVING TO TAPE..
PATT: 00
The display shows the current pattern or song being output. This display will
advance until all data Is output. Pressing the STOP button will abort the
operation. Before pressing RECORD, the
+!-
arrow buttons can be used to access
the other five tape pages. They are as follows:
CHECK TAPE DATA
FOR ERRORS_______
LOAD ALL PATTS &
SONGS FROM TAPE
LOAD ONE PATT
FROM TAPE: flO
Alesis HR-16 Instructions ............................................................................ ........................................................ Page 23