Aiwa XM-M25 - Manual (Page 8)

RADIO RECEPTION
MANUAL TUNING
SHIFT
BAND/
MODE
TUNER
1 Press TUNER/BAND repeatedly to select the
desired band.
r
FM AM
1
When an FM stereo broadcast contains noise
Press BAND/MODE TUNER while pressing SHiFT on the remote
control so that “MONO” appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press these buttons so that “MONO”
disappears.
/1
i /■ i§Ìi»lÌBSSiMìi iHHi
IMÒMÒI 1.
MONO
To change the AM tuning intervai
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press
POWER while pressing DIR/PRESET during power
on.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
When TUNER/BAND is pressed while the power is off, the
previously tuned station will be played (Direct Play Function).
To select a band with the remote control
Press BAND/MODE TUNER repeatedly.
Press ◄◄ DOWN or ►► UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, “(li®il)” is displayed.
To search for a station quickly (Auto Search)
Keep ◄◄ DOWN or ►► UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press ◄◄
DOWN or ►► UP.
• The Auto Search may not stop at stations with very weak
signals.
7
ENGLISH