Aiwa XM-M25 - Manual (Page 18)

SETTING THE TIME l
4 Select the duration for the timer-activated period
with ◄◄ DOWN or ►► UP, then press II SET.
ISsl
The unit can be turned on at a specified time every day with the
built-in timer.
iiSiSipiil i
i r
i i i
■ ; ;
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
5 Prepare the source.
To listen to a CD. load the disc.
To listen to a tape, insert the tape into deck.
To listen to the radio, tune in to a station.
To listen to the equipment connected to VIDEO/AUX jacks.
set the timer of the connected source (with an external timer)
and prepare for the play.
6 Press POWER to turn the unit off after adjusting
the volume and tone.
“©” remains on the display after the power is turned off (timer
standby mode).
Preparation
Make sure the clock Is set correctly. (See page 16).
Use the remote control.
1 Press TIMER once while pressing SHiFT to
dispiay then press II SET within 4 seconds.
“©” Is displayed and the hour flashes.
; /;
: i
EPill
■¡■ii
IpiliiSiliilSI
i / '""iSilaiB
; :.... ■/ / / /
©
If you press II SET after 4 seconds, another operation may
start.
2 Designate the hour of the timer-on time by
pressing ◄◄ DOWN or ►► UP, then press
II SET. Repeat to designate the minute of the
timer-on time.
©
iTCiSS!
: n/i
i.../ ; /
/
;.. ;
13
; i
; i
After you designate the timer-on time, one of the source names
flashes on the display.
3 Press FUNCTION repeatedly to select a source,
then press II SET.
The selected source name flashes.
\ ! /
/.........■ /■ ■ /'
/ / /
(fiisa
1^-;
13
J
' The ◄◄ and ►► are also available to select a source.
' if
TUNER is pressed, the band cannot be selected in this
step.
0
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To check the specified time and source
Press TiMER while pressing SHIFT on the remote control. The
timer-on time, the selected source name and the duration for
the timer-activated period flash alternately for 4 seconds.
To cancel timer standby mode temporarily
Press TIMER repeatedly while pressing SHIFT on the remote
control until “©” or “0 REc” disappears on the display.
To restore the timer standby mode, press
TIMER once or twice
while pressing SHIFT to display “©” or “©
rec ”.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
■ Timer playback and timer recording will not begin unless the
power is turned off.
’ Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
TIMER RECORDING
Timer recording is applicable for TUNER and AUXA/IDEO (with
an external timer) sources oniy.
Press TIMER repeatedly while pressing SHIFT on the remote
control until “0 rec ” appears on the display, then press II
SET within 4 seconds. Carry out the steps of “SETTING THE
TIMER” from step 2 and insert the tape to be recorded on into
deck after step 5.
1 7
ENGL ISH