Chauvet Obey 40 - Manual (Page 22)

Page 22 of 160 Obey™ 40 User Manual Rev. 7
Programming Two
Products
Programming products is sending DMX values to them to control them and create a look.
The general steps for programming a product are as follows:
1. Enter Program mode.
2. Press one or more buttons to select one or more products.
3. Move the channel faders to control the product or products—use to move
between fader pages.
4. Repeat steps 2–4 as needed for other products.
5. Save the look into a scene. See
Creating A Scene .
6. Exit Program mode.
Note: If the look is not saved to a scene it will be lost when Program mode is exited.
The specific instructions below describe programming a 12-channel product on and
a 15-channel product on .
1. Enter Program mode.
2. Press . Its LED comes on and it is selected.
3. Move any of the 8 channel faders to send DMX values to the first 8 channels of .
The light responds to the faders.
4. Press . The Page B LED comes on and the Page A LED goes out. Fader Page B
is now active.
5. Move any of the first 4 channel faders to send DMX values to the last 4 channels of
and the product responds to the faders.
6. Press . Its LED comes on and it is selected. Now both lights are selected.
7. Press . Its LED goes out and it is no longer selected. Now only is
selected.
8. Press . The Page A LED comes on and the Page B LED goes out. Fader Page B
is now active.
9. Move any of the 8 faders to send DMX values to the first 8 channels of . The light
responds to the faders.
10. Press . The Page B LED comes on and the Page A LED goes out. Fader Page B
is now active.
11. Move any of the first 7 faders to send DMX values to the last 7 channels of . The
light responds to the faders.
12. Repeat steps 2–11 as needed for other products.
13. Save the look into a scene. See
Creating A Scene .
Note: If the look is not saved to a scene it will be lost when Program mode is exited.