Nespresso Citiz & Co EF 488 - Manual (Page 62)

Citiz service manual 62
R E P A I R S
8.4.4 Replacing power cord
• Remove water tank connector from platform first (see page 59).
• Remove insulated faston receptacle of phase wire from mains switch (54).
• Disconnect adapter plug of neutral wire (15).
• If present, disconnect ground wire (15, see detail).
• Unlatch cable bracket (56) with screwdriver.
The hoses can
remain on the water
tank connector.
Use a pair of flat pli­
ers to pull off insulat­
ing sleeve with recep­
tacle.
The flat receptacle on
the ground wire has a
special connector
latching (see detail). Press
down lever at first, then pull
off receptacle.
The cable bracket is
under tension. There­
fore, hold the cable
bracket with your finger
when unlatching it.