Nespresso Citiz & Co EF 488 - Manual (Page 35)

Citiz service manual 35
O P E R A T I O N
5.3.2 Machine modes of milk frother AERO3
6 Emptying mode
(evaporing)
1) Switch off machine
2) Press and hold
small coffee button
3) Switch on machine
1) Start pump
2) Stop pump after
10 s
3) Heat up thermo­
block to 105 °C
(100% power)
4) Switch off ther­
moblock
5) Go to standby
mode
Switch off machine
7 Resetting mode
1) Switch off machine
2) Press and hold
large coffee button
3) Switch on machine
• Reset the
programmed large
and small coffee
volumes to factory
setting
• Indicate the resetting
mode for 3 s
Factory settings:
• small cup .... 40 ml
• large cup ... 110 ml
proceeds with self test
mode automatically
8 Power save mode
To enable power save
mode:
1) Switch off machine
2) Press and hold
both coffee buttons
3) Switch on machine
4) Coffee button
LED‘s blink 5 times
alternatively as
confirmation
After that automatically
after 30 min of non use
• Reduce thermoblock
temperature
• Switch LED indica­
tion to power save
mode (blinking alter­
nately every 2 sec)
Press any coffee but­
ton to activate ready
mode
To disable power save
mode:
1) Switch off machine
2) Press and hold
both coffee buttons
3) Switch on machine
4) Coffee button
LED‘s blink 3 times
alternatively as
confirmation
9 Failure mode
Automatically by fol­
lowing failures:
a) NTC short circuit
b) NTC not connected
c) Heat up too slow
Machine indicates fail­
ure with coffee button
LED‘s as long as the
failure is present
When failure is fixed
10 Standby mode
Automatically after
emptying mode
• Switch thermoblock
off
• Switch LED indica­
tion to standby mode
Switch off the machine
Machine mode Enter mode Actions Exit mode
1 Hot milk / milk froth
preparation Press start button
briefly
Start button lights up
red. Milk is heated and
mixed.
Automatic switch­off
after preparation
2 Cold milk froth prepa­
ration
Keep start button
pressed for approx.
2 sec
Start button lights up
blue. Milk is mixed only. Automatic switch­off
after preparation
Machine mode Enter mode Actions Exit mode