Service and adjustments, Engine – Poulan CHDR500C User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fiq ?9)
^ L'r i-r-n cabie damp screw to aliow cable to move.
» Mcvf pPrcîtle control lever on upper handle to “FAST”
position.
•
Pull throttle cable out until engine bellcrank is back as
far
as it will go.
•
Hold cable in this position and tighten clamp screw
securely.
TO ADJUST CARBURETOR
The
caCiivetor h-i';
a
hign
'.peerljetr.nd
has been prose i si
toe factory and adiusmien» should oof be rtecessary. H o w -
e / ç r . rifrvjr adi-i-imcfts mov be required m r/:.fripensate
for differences in fuel, femperatur , altitude or load,
it the
carburetor dess need .5d!us»mert, sse engine 'oanual,
IMPORTANT;
NEVEH
TAMFEFt
WITH
THE
ENG'HE
GOVERNOR, WHtoH IS FACTORY SET FOR PROPER
ENGINESPEED
OVERSPEEDING
THE
ENGINE
ABOVE
THE
FACTORY
HIGH
SPEED
SETTING
CAN
BE
DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED
HIGH
SPEED
NEEDS
ADJUSTING,
CONTACT
YOUR
NEAREST
AUTHORIZED
SERVICE
CENTER/
DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT
AND
EXPERIENCE
TO
M A K E
A N Y
N E C E S S A R Y
ADJUSTMENTS.
18