Cultivating, Operation – Poulan CHDR500C User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
CULTIVATING
Cultivaf.Ttg deai;nyini} the v/eefJe bf*we^n row- 'o pre
vent them from robbinq nourishmepi: and mc-islure from the
plarto.
At
the
same
tirr*, troaking
up
the
upcei ¡ayer of e ai!
cruet #iil help retain moisture in »he soi! Best digging depth
!£ 1'^ to 3" f2 5 - t ^ , 5 cm) Lower the outer sde shieids to
protect email plants from being buried.
• Cuitivaie up and down the rows at a speed which wili
allow tines to uproot weeds and leave the ground in
rough condition, promoting no further growth of weeds
and grass (See Fig. 15).
0 0 0 0 C'
o 0 o 0 0
o 0 0 0 0
0 0 0 0 0
V /
LJ
FIG. 15
ADJUST WHEELS FOR'CULTIVATING (See
Figs. 16 and 17)
•
Place blocks under right hand side of tiller and remove
hairpin clip and clevis pin from right hand wheel.
•
Move wheel outward approximately 1 inch (2.5 cm)
until hole in inner wheel hub lines up with inner hole in
axle.
•
Replace clevis pin and hairpin clip on inside of wheel
and remove blocks.
® Repeat preceding steps on left hand side.
NOTE; Inextremeiy rough conditions and while cultivating,
the wheels should be moved outward on the axle for
increased stability.
12