beautypg.com

Dealer assembly & pre-service, Battery set-up and maintenance – Ariens 935000 User Manual

Page 36

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

DEALER ASSEMBLY & PRE-SERVICE

BATTERY SET-UP

AND MAINTENANCE

A

WARNING:

STORAGE

BATTERIES

GIVE

OFF

HIGHLY

INFLAMMABLE

HYDROGEN

GAS.

DO

NOT

ALLOW

SPARKS OR FLAME NEAR BATTERY. DO NOT LAY

TOOLS

ACROSS

BATTERY

TERMINALS

WHICH

MAY

CAUSE A SPARK RESULTING IN AN EXPLOSION.

CAUTION:

ELECTROLYTE

CONTAINS

SULPHURIC

ACID

WHICH

IS

HARMFUL

TO

SKIN,

-EYES

AND

CLOTHING.

HANDLE

WITH

EXTREME

CARE.

IF

SPILLAGE OCCURS ON BODY OR CLOTHING, RINSE

AT ONCE WITH WATER.

WARNING:

REVERSED

BATTERY

CABLES

OR

REVERSED CABLES FROM A BATTERY CHARGER OR
BOOSTER

BATTERY

CAN

CAUSE

DAMAGE

TO

THE

PRODUCT.

SPARKS

AND

POTENTIAL

HAZARDS

TO

OPERATOR

COULD

RESULT.

MAKE

CERTAIN

THE

GROUND CABLE IS CONNECTED TO THE FRAME AND
THE

POSITIVE

CABLE

IS

CONNECTED

TO

THE

POSITIVE (+) TERMINAL.

NOTE: THE HYDROMETER, PART NO. 531 140, OF­
FERED

THROUGH

ARIENS

IS

RECOMMENDED

FOR

ALL

SET-UP

AND

MAINTENANCE

PROCEDURES

OF

ARIENS BATTERIES.

SET-UP

Battery is dry charged. Dealer or customer must add
electrolyte (sulfuric acid and water).

1. Remove battery from unit.

2.

Remove all the vent caps from the battery and set

the caps to ope side.

3.

Take

the

electrolyte

which

should

be

1.265

Specific gravity at 80° F,* and fill each cell so that
the electrolyte is level with the bottom of the fill
ring.

4.

The battery should stand for

’/2

hour. Now check

electrolyte level in each cell again. If necessary
add more electrolyte to bring the level up to the
bottom of the fill ring.

5.

Charge until all cells are gassing freely, and the

specific gravity is constant over three successive
readings taken at 30 minute intervals. See Table 4
for charging rates.

6.

Immediately after charging check level of elec''
trolyte. If the level is low add distilled water to

bring it up to required level.

v

7. Replace vent caps. It is not necessary to tighten

more than finger tight.

8. Wash off the battery to remove electrolyte which

may have spilled.

PRODUCT

BATTERY
MODEL

CHARGE

RATE

FOR 10 HRS.

Yard Tractor

Ariens 291 75

(WISCO LM-9)

2.5 Amps

TABLE 4

NOTE: CHARGING BATTERY AT A HIGHER RATE WILL
DAMAGE BATTERY.

MAINTENANCE

If you wish to have the best performance possible, it is
extremely important to do periodic checks.

1.

Do an occasional visual inspection. See to it that

the battery remains clean' both the case and the
terminals. This visual inspection should be done
once a month.

2.

Check the level of the electrolyte. It may be

necessary to add distilled water. This should be

checked before each usage.

3.

Another important check is the specific gravity.

The specific gravity should be checked with the

Hydrometer*. The reading on the gauge should be

above 1.225. If the electrolyte is allowed to fall

below 1.225 specific gravity, you will have an in­
sufficient charge. If this happens charge battery

until specific gravity of 1.265 is reached over 3
successive readings. This check should be done
monthly.

STORAGE

During the off season it is important to have the battery
in the same good condition or it will not deliver power
when needed.

1.

Make sure the battery is fully charged and the

electrolyte is to the proper level.

2.

Make sure the battery is clean (both the case and

the terminals.)

3.

After cleaning the terminals you may want t,

spread petroleum jelly on the terminals to prevent
loss of charge.

4.

Leave the cables disconnected.

3 6 -