beautypg.com

Maiimteimaimce, General, Raising the hood - figure 18 – Ariens 935000 User Manual

Page 12: Raising the rear deck - figure 18, Air cleaner service - figure 19, Engine cooling system - figure 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

MAIIMTEIMAIMCE

CAUTION;

REMOVE

BATTERY

FROM

TRACTOR

BEFORE

TIPPING

OR

LIFTING

THE

UNIT

FOR

AD­

JUSTMENTS. BATTERY IS NOT SEALED AND SPILLED
ACID

WILL

DAMAGE

PRODUCT.

WHEN

HANDLING

BATTERY BE SURE TO AVOID CONTACT WITH BAT­

TERY ACID, WHICH CAN CAUSE SERIOUS INJURY TO
EYES,

ETC.

FOLLOW

ALL

CHARGING

INSTRUCTIONS

CAREFULLY. WHEN "JUMP STARTING" THE UNIT BE
SURE TO CONNECT THE NEGATIVE BOOSTER CABLE

TO FRAMES (NOT TERMINAL.)

GENERAL

All dealers will provide any service which may be re­
quired to keep the Yard Tractor operating at peak effi­
ciency. Ariens Company recommends that you contact

an Ariens dealer before making any adjustments to this

tractor.

Refer

to

the

Engine

Instructions

for

engine

maintenance instructions. If repairs or service are re­
quired for the engine, see your Ariens dealer or the

nearest authorized engine service station.

RAISING THE HOOD - FIGURE 18

1.

The

engine,

battery,

electrical

components,

air

cleaner, fuel filter and fuel tank are readily ac­
cessible by raising the hood.

operating in extremely dusty conditions, perform thi<^^
service at more frequent intervals. Use the followinv
procedure to service the air cleaner.

1.

Raise the tractor hood. Remove screws, "A", Figure

1 5, and lift off complete air cleaner assembly.

2.

Remove screen and spacers from the foam ele­

ment, Figure 1 9.

3.

Wash

foam

element

in

kerosene

or

liquid

detergent and water to remove dirt. Wrap foam in
cloth and squeeze dry. Let dry overnight.

4.

Saturate foam element in clean oil. Squeeze to

remove the excess oil.

5.

Re-assemble

parts

and

re-install

complete

assembly on the carburetor.

NOTE:

WHEN

RE-ASSEMBLING

THE

PARTS,

MAKE

CERTAIN THE FOAM ELEMENT EXTENDS OVER THE
EDGE OF THE AIR CLEANER BODY. THE FOAM ELE­
MENT WILL FORM A PROTECTIVE SEAL.

IMPORTANT: NEVER RUN THE ENGINE WITH THE AIR
CLEANER REMOVED!

2. To raise the hood, grasp each side and raise it up­

wards and forward until it stops.

RAISING THE REAR DECK - FIGURE 18

The

trahsaxle,

PTO

and

jackshaft

assembly,

clutch

idler, and Traction Drive Belt are readily accessible by
raising the rear deck until the seat rests against the
steering wheel.

SPACERS

LIFT UP

LIFT UP

AIR CLEANER SERVICE - FIGURE 19

Clean the air cleaner and re-oil the element every 25

hours under normal operating conditions. When

ENGINE COOLING SYSTEM - FIGURE 20

1. The engine is air cooled. Grass particles, chaff and

dirt may clog the cooling systehi, especially when
mowing dry grass or operating in extremely dusty
conditions.

Continued

operation

with

a

clogged

cooling system may cause severe overheating and
possible engine damage.

^

2.

It is essential that the rotating screen, engine cool­

ing fins and the exhaust system be kept free of
dirt and debris which could cause the engine to
overheat.

- 12