SINGER 2543 - Manual (Page 59)

• Turn the machine off.
• Insert the twin needle with the flat side of the
shank toward the rear of the machine.
• Thread the machine as you normally would
for single needle stitching, and pass the
thread through the left eye of the twin needle.
• Insert a second spool pin into the hole on the
top cover of the machine, as illustrated.
• Thread the machine in the usual way.
• Pass the thread through the remaining points,
making certain to omit the thread guide just
above the needle and pass thread through
right eye of needle.
• Draw both threads under the foot and back
along with the bobbin thread.
• Slowly lower the needle into the hole in the
needle plate by turning the hand wheel toward
you to make sure the needle clears the plate.
Caution:
Make sure not to use a stitch width greater
than mid point on the stitch width dial
when twin needle stitching.
55