Corded overlook, Machine setting, Fabric – SINGER WSL2000 ATS (Part 1) User Manual
Page 32: Tension settings
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CORDED OVERLOOK
The Specialty Technique Guide consists
of the snap on cord guide (1) found in your
accessory pouch, the guide above the
needles (2) and either hole in the presser
foot (3).
The Specialty Technique Guide guides cord
through the foot and then is covered by the upper
looper thread or is caught by the right needle,
depending on the size of cord you choose. Ribbon
or Cording can be used to stabilize where stress
occurs: joining shoulder seams, sleeves, side
seams, etc. You can also use it for a decorative
look in the areas that are visible. Use filler cord,
perle cotton, twill tape, gimp, wool yarn, elastic
thread, polyester ribbon, etc.
Machine Setting
Stitch Length: 2.5 - 3
Stitch width: 6
3/16' Ribbon
Fabric
Sweatshirt Fleece & 1/8*
Tension Settings
Normal
(LN) - 4 -
(RN)
-4-
(UL)
-4-
(LL) -4-
•Feed ribbon through guides and front hole on foot.
•Fold fabric in half.
•Serge with four thread seam to stabilize seam.
•Use the back hole in foot for cording, fishline, etc.
Slide ribbon under foot to needles.
30