SINGER 301 - Manual (Page 30)

56
To Make a Ruffle and Attach it with a
Facing in One Operation
1. Insert material to be ruffled between two
blue blades and under separator guide (Line
2, Fig. 66).
2. Place material to which ruffle is to be at­
tached under separator blade and under sepa­
rator guide (Line 1, Fig. 66).
3. Place facing material over upper blue blade
(Line 4, Fig. 66).
4. If facing is to be on right side of garment,
place wrong sides of garment and ruffle to­
gether.
5. If facing is to be on wrong side, place
right sides of garment and ruffle together.
Fig, 67, Making a Ruffle and Attaching it
ivith a Facing in One Operation
57
To Pipe a Ruffle
1. Insert material to be ruffled between two
blue blades from the right (Line 3, Fig. 68).
This material must not exceed 1-1/4 inches in
width.
2. The piping material is usually cut on the
bias and it should be about 1/4 inch wide
when folded in center. Place piping material
in ruffler, following (Line 5, Fig. 68) with
folded edge of piping to right.
3. Fold edge of material to which piping and
ruffling are to be attached and insert it in
ruffler, from the left following (Line 6, Fig.
68
).
Fig, 69, Piping a Ruffle