Zwmimo, Before starting the machine: fig, Other lubricating points – SINGER 1371A2 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
l>l#Singer
”^ito
lUTBiiS'^iPyi
o
* ®8
^zwmimo
* Before starting the machine:
Fig ?
1) Fill the oil reservoir of the machine base with singer oil type C up to the level indicated
by "HIGH”.
2) Supplement the oil when the oil level has lowered below the bottom line of oil gauge
3) When the machine has been properly lubricated, the oil is seen to run through the pipe
from oil sight window (D. (Low speed operation permits easier observation of the
lubricating oil.)
Drain dirty oil by loosening oil drain screw ®, and fill the oil reservoir with fresh oil.
* Adjusting the lubrication for the sewing hook
Fig.s
Adjust the volume of lubricating oil supplied to the sewing hook by turning oil adjusting
screws ® for rough adjustment, and (D for fine adjustment; oil volume is reduced when
turning the screws clockwise.
* Other lubricating points
1) Apply one or two drops of lubricating oil to the arrowed points once a week or every
other week.
2) Apply two or three drops of lubricating oil only to (S) point when the machine is
newly set up or has been out of use for a long time.
12