Onkyo TX-8211 - Manual (Page 4)

Precautions
1. Warranty Claim
You can find the serial number on the rear panel. In case of war­
ranty claim, please report this number.
2. Recording Copyright
Recording of copyrighted material for other than personal use is
illegal without permission of the copyright holder.
3. AC Fuse
The fuse is located inside the chassis and is not user-serviceable.
If power does not come on, contact your Onkyo authorized service
station.
4. Care
From time to time you should wipe the front and re;ir panels and
the cabinet with a soft cloth. For heavier dirt, dampen a .soft cloth
in a weak solution of mild detergent and water, wring it out dry.
and wipe off the dirt. Following this, dry immediately with a clean
cloth. Do not use rough material, thinners, alcohol or other chemi­
cal solvents or cloths since these could damage the finish or
remove the panel lettering.
5. Power
WARNING
I3EFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
• Some models are designed for use only with the power supply
voltage of the region where they arc sold.
European and Ausiralian inodelsiAC 230V. 50H/.
U.S. and Canadian models;
AC 120V, 60Hz
Worldwide model: AC 220-230V/I20V swilchabic,
50/60HZ
Other: AC 220V, 60Hz
• Voltage Selector (Rear Panel)
Worldwide models are equipped with a voltage selector to con-
, foiln to local power supplies. Be sure to set this switch to
match the voltage of the power supply in your area before
plugging in the unit. (See page 5.) Models wilhout a voltage
.selector can only be u.sed in areas where the power supply is
the same as that of the unit.
• The power does not shut off completely by just turning the
power off. So power cord should be removed froiii AC outlet
when not in use for a prolonged time.
Supplied accessories
Remote control RC-330S (1)
Battery (size AA. R6, or UM-3) (2)
AM loop antenna (1) T-shaped FM antenna (1)
Memory Preservation
This unit does not require memory preservation batteries. A built-in
memory power back-up system preserves the contents of the mem­
ory during power failures and even when the unit is unplugged. The
unit must be plugged in order to charge the back-up .system.
The memory preservation period after the unit has been unplugged
varies depending on climate and placement of the unit. On the aver-
iige, memory contents are protected over a period of a few weeks
after the last lime the unit has been unplugged. This [>eriod is
shorter when the unit is exposed to a highly humid climate.