Onkyo TX-8211 - Manual (Page 15)

Receiving stations
г
2
h't
I I I I I I I
h'l
I I I
U I . . I I I I I
-J u. и
i . l h ' l I . . I i , I I
I I I I l i . L'U"*
Please make sure lhai the IT-2 MONITOR I
and AUDIO MUTE indicators are not lit.
Tuning the radio (Mahui^'^
tuning and Direct tunlHg)'^;н^Н
When the frequency is not known (Man­
ual tuning)
1. Press the FM or AM button.
2. Use the ◄ DOWN TUNING UP ►
buttons to change the frequency.
UP............. the frequency increases.
DOWN the frequency decreases.
• The frequency is changed in 100 kHz
(or 50 kHz) steps in FM and 10 kHz (or
9kHz) in AM each time a tuning selec­
tor button is pressed.
• If a button is held continuously for
more than 0.5 seconds, the frequencies
are scanned automatically. (FM auto
tuning mode)
When a broadcast is received, scanning
' stops.
OOMH T umn G
taHtCT lUMiHC
a
I h / l L J I - ' I
I I I I I I I
I h ' l
I lb_____ .
I . I''I i . j O
I I I u u . ^ - ' -
о
L. b'l
I I I
I I I . I I I I
U U . I L/„
When the frequency is known (Direct
tuning)
1. Press the F.M or AM button.
2. Press the DIliECl' TUNING button.
The will flash for 16 seconds in
the frequency display.
i . Enter the frequency with the number
buttons while the cursors are flash­
ing.
E.xample: K8.10 M Hz 8 ^ 8 I -» 0/10
• When receiving AM broadcasts with a
9 kHz step (this depends on your
region), you can enter the frequency
directly.
With 10 kHz steps, entering a number
for the 10 kHz digit will .set the 1 kHz
digit automatically to 0.
• If you enter a frequency that is out of
range, this unit will return to the previ­
ous frequency. If this happens, repeat
the procedure.
15