beautypg.com

To adjust mower cutting height (see fig. 10), To operate mower (see figs. 10 and 11), To operate on hills – Sears 917.257462 User Manual

Page 12: To transport, Before starting the engine, Check engine oil level (see fig. 16), Starting the engine, Operation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

OPERATION

TO ADJUST MOWER CUTTING HEIGHT

(See Fig. 10)

The position of the mower iift lever determines the cutting

height. The position of the mower lift lever can be adjusted
by moving the height adjustment knob to desired position.

With lift lever back and locked in highest position, pull

out the adjustment knob and move to desired position.

Move mower lift lever out and forward to adjustment

knob.

The cutting height range is approximately 1" to 3-112". The

heights are measured from the ground to the blade tip with

the engine not running. These heights are approximate
and may vary depending upon soil conditions, height of
grass and types of grass being mowed.

The average lawn should be cut approximately 2-1/2

inches during the cool season and over 3 inches during
hot months. For healthier and better looking lawns,
mow often and after moderate growth.

For best cutting performance, grass over 6 inches in

height should be mowed twice. Make the first cut
relatively high; the second to desired height.

MOWER LIFT
LEVER

MOWER HEIGHT

ADJUSTMENT KNOB

FIG. 10

TO OPERATE MOWER (See Figs. 10 and 11)

Your unit is equipped with an operator presence sensing
switch. Any attempt by the operator to leave the seat with

the engine running and the mower clutch engaged will shut

off the engine.

Select desired height of cut.

Engage mower by slowly moving mower clutch lever to

"ENGAGED" position.

TO STOP MOWER - Move mower clutch lever to

"DISENGAGED" position.

A

CAUTION: Do not operate the mower

without either the entire grass catcher,
on mowers so equipped, or the dis­
charge guard in place.

MOWER

CLUTCH LEVER

'ENGAGED’

POSITION

MOWER

CLUTCH LEVER

'DISENGAGED'
POSITION

FIG. 11

TO OPERATE ON HILLS

A

CAUTION: Do not drive up or down

hills with slopes greater than 15° and

do not drive across any slope.

Choose the slowest speed before starting up or down

hills.

Avoid stopping or changing speed on hills.

If slowing is necessary, move throttle control lever to

slower position.

If stopping is absoiutely necessary, push clutch/brake

pedal quickly to brake position and engage parking
brake.

Move gearshift lever to 1 st gear and be sure you have

allowed room for tractor to roll slightly as you restart

movement.

T

0

restart movement, slowly release parking brake and

clutch/brake pedal.

Make all turns slowly.

TO TRANSPORT

Raise mower lift lever to highest position.

When pushing or towing your unit, be sure gearshift

lever is in "NBJTRAL" position.

Do not push unit at more than five (5) MPH.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL (See Fig. 16)

The engine in your unit has been shipped from the

factory already filled with summer weight oil.

Check engine oil with unit on level ground.

Remove oil fill dipstick and wipe clean, replace and

screw cap tight, wait for a few seconds, remove and
read oil level. If necessary, add oil until "FULL" mark
on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for

easier starting (see "OIL VISCOSITY CHART" in the

Maintenance section of this manual).

To change engine oil, see the Maintenance section in

this manual.

12