Picking up bobbin thread – Sears 1345 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PICKING UP BOBBIN THREAD
1.
Raise presser foot lever. Hold needle
thread loosely in left hand and rotate
handwheel
toward
you
one
complete
turn.
2.
Bring bobbin thread up by pulling upper
thread.
3,
Pull both threads under and to the back
of the presser foot, leaving 3 to 4 Inches
of thread clear.
If you can not pick up bottom thread by
following above steps, then check:
1. Is thread through needle ?
2. Is thread tangled around needle ?
3. Is there 3 to 4 inches of thread coming out
of bobbin case ?
,
4. Is thread from bobbin case tangled ?
11