Item, Description, Assembly – Sears 113.20765 User Manual

Page 6: Assembling steel legs

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Item

2
3
4

Description

Screw, Serrated Truss Hd
Leg ...... ............ .........

Stilfener, Side .............. .

•Lockwasher, Ext 1/4

*Nut. Hex 1/4^20 .........

Stiffener, End ........ ....
*Nut, Hex 1/2-13 ..........

Foot, Leveling ...............

‘Washer 17/64 ID...........
Screw Hex Hd 1/4-20 x 1-

1/4-20 x 5/8 .

1/4

Olr

4
2

"Parts contained in Loose Parts Bag No 56037

assembly

SPECIAL NOTE; it is normal for this scroll saw to

vibrate during operation. For this reason the scroil
saw MUST be fastened down securely to a leg set or
workbench during operation.

This Leg Set is inciuded with Mode! No 113 207660

only.

NOTE: For illustrative purposes, the Scroll Saw is

shown mounted on the Craftsman Catalog No 9

22239 Steel Leg Set

ASSEMBLING STEEL LEGS

T insert the Truss Head Screws through the holes

in the legs, then through the holes in the

stiffeners. MAKE SURE THE SCREWS GO

THROUGH

THE

HOLES

THE

SIDE

STIFFENERS MARKED “X"

2 install lockwashers and screw on the nuts, butdo

not tighten until completely assembled.

3. install leveling feet as shown. To level Leg Set,

loosen nut on inside of leg and turn nut on outside
to raise or lower feet. Adjust all four ievelers, if
necessary, and then tighten nuts on inside of leg

NOTE: These Ievelers are not intended for height

adjustment

SIDE STIFFNER

END

STIFFNER

SCREWS THROUGH

HOLES MARKED ‘X"

1/2 IN- HEX NUTS

LEVELING FOOT

This manual is related to the following products:

113.2076