Sears 113.20765 - Manual (Page 10)

assembly
Locate table insert among loose parts and install
in table by sliding the insert in place from back to
front of blade, aligning rear tab on back of insert,
and pushing downward on front of insert
ADJUSTING INSERT TO TABLE
If insert is higher than table top. adjust insert by
tapping lightly with hammer at each tab location
until insert is flush with table top
If insert is lower than table top. adjust insert by
slightly bending down all four tabs with a needle
nose pliers
TENSIONING TENSION KNOB
TENSIONING THE BLADE-
To apply the proper tension to the blade after blade
and holders are securely in place, turn the tension
knob clockwise BY HAND until tight (5 ful
revolutions with a wide blade; up to 7 fu!
revolutions with a narrow blade) DO NOT use any
type of mechanical device or tool on tension knob
As tension is being applied, recheck the alignment
of the blade holder notch in the end cap slot
To check blade tension -push thumbagainstsideof
the blade in the middle Blade should move only
slightly with moderate pressure
NOTE: Blades tend to break more easily with too
little tension than with too much tension
TO CHECK BLADE fNSTALLATION-
With blade properly installed and tensioned, place
fiat-head screwdriver in motor slot and rotate
manually by turning screwdriver to check correct
installation and clearance of the blade.
, REtEASING
TENSION
10