Adjusting the blade square to table – Sears 113.20765 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING THE BLADE SQUARE
TO TABLE
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF”, REMOVE KEY AND REMOVE
PLUG FROM POWER SOURCE OUTLET.
r WITH BLADE INSTALLED AND TENSIONED,
place combination square on side of bSade.
Guard prevents placing square directly against
blade, so gauge squareness of blade to table by
viewing from side of saw.
HOUSING
if an adjustment is necessary, loosen four (4) hex
bolls located at back of lower arm on saw using
7/16” wrench- Align blade square to table by
tilting
housing
forward
or
backward,
and
retighten all four (4) bolts
NOTE: Make certain the blade is centered in the
insert
opening
Readjust
if
necessary
by
loosening four hex head bolts and moving
housing to center the blade Retighten bolts
Place square in front of blade. Guard prevents
placing square directly against blade, so gauge
squareness of table to blade by viewing from front
of saw
If an adjustment is necessary, loosen bevel lock
knob located under base and rotate housing
slightly to align blade to combination square
Tighten bevel lock knob
13