To install/tension pin type blades, To remove plain-end or pin type blades – Sears 113.20765 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO INSTALL/TENSION PIN TYPE
BLADES:
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH “OFF", REMOVE KEY AND REMOVE
PLUG FROM POWER SOURCE OUTLET BEFORE
REMOVING OR INSTALLING BAWBLÄDE.
Locate two (2) blade holders among loose parts
Blade clips and set screws are not needed in
blade holders with pin type blades; they can be
stored in base of unit, if previously installed there
is no need to remove clips and screws, but set
screws should be securely tightened in holders
Place each blade holder in upper and tower arm
cap ends (with pin-blade slot closest to table} by
pulling retainer clips up and aligning notches in
blade holders with slot in cap Position pin-blade
slot towards tabie and front of saw for easy
access
Locate two (2) blade holder keys among loose
parts.
Position one key over top holder, and one key
under bottom holder to secure holders while
installing blade.
install (pin type) blade first in lower blade holder,
then in upper blade holder by sliding pin into pin
blade slot.
Apply tension by turning tension knob clockwise
BY HAND until tight (5 full revolutions with a
wide blade; up to 7 full revolutions with a narrow
blade) DO NOT use any type of mechanical
device or tool on tension knob (See:
TENSIONING THE BLADE).
Remove blade holder keys from upper and lower
blade holders and store keys lor future use
TO REMOVE PLAIN-END OR
PIN TYPE BLADES
WARNING: FOR YOUR OWN SAFETY. TURN
SWITCH “OFF”, REMOVE KEY AND REMOVE
PLUG FROM POWER SOURCE OUTLET BEFORE
REMOVING OR INSTALLING SAWBLADE.
1 Remove table insert by pushing gently upward at
back of insert and pulling back of insert up to
release front insert tab Move insert backward to
dear blade from insert siot.
2 Release tension knob by turning counter
clockwise until blade assembly is loose
NOTE: Do not turn knob beyond point where blade
loosens because the knob could disengage if
turning continues if knob is turned too far and
disengages from rod, slowly lift up on outer end of
upper arm to expose threaded rod Carefully
engage flat washer and knob on rod, and tighten
knob
11