Removing correction tape, Installing correction tape, How to change correction tape – Sears 16 User Manual
Page 67
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing Correction Tape
4. HOW TO CHANGE CORRECTION TAPE
1
.
1
)
2)
3)
Turn off the machine. Open the Top Cover and remove
the Ribbon Cassette as explained under “Removing Rib
bon Cassette".
Remove the left and right spools from the respective spin
dles. Be sure not to puli on the spindle hub when remov
ing the right spool.
Grasp both spools and bring back to a position that is
parallel with the tape Guides, Pull on the Correction Tape
to take up any slack and lift it out of the typewriter.
2
.
1
)
2)
installing Correction Tape
While holding the two spools in your hands, unwind the
Correction Tape and position behind the Tape Guides and
Printwheel as shown. Make sure that the sticky side of
the tape faces the Card Holder.
Fit the full spool of the Correction Tape onto the Right
(Supply) Spindle. Then fit the left spool (the one with the
knob) onto the Left (Takeup) Spindle.
3)
Turn the left spool counterclockwise until the colored por
tion of the tape disappears.
• Check again to make sure that the Correction Tape has
been fed properly behind the left and right Tape Guides.
4)
Replace the Ribbon Cassette and close the Top Cover.