All file space used, Out of memory, Stop code – Sears 16 User Manual
Page 39: Entering stop codes, Using stop code during recalling (printing), S) + 0
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ALL FILE SPACE USED
___________ ▼
4. All File Space Used
If you specify a new file and there are already 50 files in
the typewriter memory, "ALL FILE SPACE USED” appears
on the LCD.
In this case, one file must be deleted to create a new file.
(Refer to “File Deleting”.)
OUT OF MEMORY
__________ ▼
5. Out of Memory
If you run out of memory, "OUT OF MEMORY” appears
on the LCD.
In this case, press the Mode Key to store entered text
and return to the NP mode. Unneeded file(s) must be
deleted to make room in the memory for your present file.
(Refer to "RIe Deleting”.)
2. STOP CODE
To stop printing at locations in a file in order to type words
or phrases during recalling (printing), enter stop codes
while storing or editing the file.
1. Entering Stop Codes
1)
Flold down the Code Key and press the “7” Key at the
position you wish to stop in the file. A highlighted “S” is
displayed on the LCD.
You can remove the stop code by deleting the character
“0” with the Correction Key.
2)
An "X”, which stands for the stop code, is printed on the
paper when the line is printed while you are storing the
file. (When entering stop codes while editing the file, an
“X” is not printed.) The “X” is only an indicator, and will
not appear during recall (printout).
STOP CODE
34
Type text ^
RECALL
(S) + 0
PRINTOUT
2.
1
)
2
)
3)
Using Stop Code During Recalling (Printing)
When the typewriter has stopped at a stop code during
printout, “STOP CODE” appears on the LCD.
Type desired text.
Hold down the Code Key and press the "6” Key to restart
printout. (Refer to “File Recall”.)