Sears 113.206930 - Manual (Page 7)

un packing and check :ing
TABLE OF LOOSE PARTS
The Following Parts Are Included With
Item
Model 113.206830 Only
No. Description Qty.
A Leg .......................... ..
B End Stiffener . . . . . .
. 2
C Side Stiffener .................... . 4
D Motor Support ................... . 1
E Motor ...................................
Package of Miscellaneous Small Parts,
No. 67035, Consisting of the Following:
F Cord Clip..............................
G Hex Nut, 1 /4 in. — 20
(approx, dia. of hole 1 /4 in ) . 40
G Hex Nut, 5/16 in. - 18
(approx, dia. of hole 5/16 in ) . . 7
G Hex Nut, 1/2 in. — 13
(approx, dia, of hole 1 /2 in.) .......................... . 8
H Truss Hd. Screw, 1/4 in. — 20 x 5/8 in.
long. (Top of screw is rounded) ...................... . 40
J Flat Washer (dia. of hole 11/32 in.) .................. . 7
K Lockwasher, 1/4 in. External Type
(approx, dia. of hole 1/4 in.) ........................... . 40
K Lockwasher, 5/16 in. External Type
(approx, dia. of hole 5/16 in.) ......................... . 7
L Carriage Bolt, 5/16 in, — 18 x 3/4 long .. . 3
M Leveling Foot ...................................... ............. . 4
N Hex Hd. Screw, 5/1 6 in. — 18 x 2 in. . .. . 3
embiy
ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished with Model 113.206930.
From among the loose parts, find the following Hardware:
TRUSS HD. SCREW
1/4-20 X S/8
END
STIFFENER
END STIFFENER
5/8 40 Truss Head Screws, 1/4-20 x
40, Lockwashers, 1/4-External
40 Hex Nuts, 1/4-20
8 Hex Nuts, 1/2-13
4 Leveling Feet
1. Assemble two (2) Side Stiffeners together using four |4)
1/4-20 Truss head screws,, lockwasher and nuts. Make
two f2) Side Stiffener assemblies.
The End Stiffeners are placed on top and at each end of
Side Stiffener assemblies as shown. Align holes, letter
coded "B" in Side Stiffeners and End Stiffeners and
then insert 1/4-20 Truss head screws through the 9/32
diameter holes letter coded "C" and install lockwashers
and nuts and then tighten.
2. Assemble the four (4} Legs
Stiffeners using 1/4-20 screws,
shown.
to the Side and End
lockwashers and nuts as
Assemble the Motor Support to the Legs with 1/4-20
screws, lockwashers and nuts. Motor Support can be
assembled to either end of Leg set.
Install leveling feet as shown. To level Leg Set, loosen
nut on inside of leg ancf turn nut on the outside to raise
or lower feet. Adjust ail four leveling feet, if necessary,
and then tighten nuts on the inside of leg.
NOTE: These levelers are not intended for height
adjustment.
1/2-13 HEX NUTS
LEVELING FOOT