Cutter – Sears 113.206930 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HEAD
e. Adjust 45° stop in the same manner.
NOTE: Tilt scale will not require adjustment if it
was adjusted for 90° position.............
. CUTTER GUARD. Provides protection over the
cutter head; It must always be in place and function
ing properly.
Check the guard to make sure it is functioning pro
perly.
V. '■ '■
a. Position fence to right for maximutn width of cut.
b. Pass a 1/4 in. thick piece of wood over cutterhead
between quard and fence. ^ ^
Guard must return automatically to "rest position"
against fence when free of the wood.
If guard does not return automatically, see Trouble
Shooting and Maintenance Sections.
CUTTER
GUARD
FENCE
CROWNED CUT
INFEED
TABLE:MUST
always
be
PARAL
LEL TO THE OUTFEED
table
.
If the cut edge or surface of the workpiece is
CROWNED, it is an indication that the OUTWARD
END of the INFEED table is HIGH and must be
adjusted.
If the cut edge or surface of the workpiece is CON
CAVE, it is an indication that the OUTWARD END
of thè I
nfeed
table is
low
and must be adjusted.
Check the infeed table to determine the "out of
parallel" condition.
INFEED TABLE
END HIGH
CONCAVE CUT
INFEED TABLE LOW
14