Mainferiance, Maintenance, Blade – Sears 113.206930 User Manual
Page 22: Mark slots
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

mainferiance
7. Remove the six lifter screws. (Two under each blade.)
8. Clean cutterhead, wedges and screws thoroughly with
Crafteman Gum and Pitch Remover. Also remove the
oil from new blades,
9. Replace the six lifter screws and screw them in alf the
way, but do not tighten. Mark each slot 1, 2, and 3,
This will help you in setting the blades.
5/32
IN.
SETSCREW
WRENCH
BLADE
LIFTER
\
WEDGE
LOCKSCREW.
SCRE’"' ^
CUTTER
HEAD
SETSCREW
MARK SLOTS
10. Insert a blade in slot marked 1 ..
in. beyond end of the cutterhead.
. so it projects 1/16
1/8 IN. SETSCREW WRENCH
11. "Insert a wedge next to blade so the flat side of the
wedge is against the blade. Push wedge in manually —
do not install two locking setscrews at this time."
12. Place head of square on outfeed table. Loosen lifter
screws to raise blade until it just touches square and
slightly raises it. Gently turn cutter head back and
forth with thg^^^ p^
raising blade. The blades
shodld be adjusted just slightly above the outfeed
table, by approximately ,003 in. (thickness of an
average piece of paper).
NOTE: Sears has a knife setting gauge for this purpose. Cat.
# 9-2647
13. "Now install both locking setscrews and tighten (with
the 5/32" setscrew wrenchl alternately a little at a
time. Tighten both screws securely. Recheck the blade
to make sure it did not change position."
14. Install other two blades the same way.
22